Step 3: Remove the Old Coil

1. Unscrew the Old Coil: The coil is located at the bottom of the Tank. To remove it, simply turn it counterclockwise until it comes off.
2. Dispose of the Old Coil: Place the used coil on a paper towel or cloth to be properly disposed of later.

Step 4: Prepare the New Coil

1. Prime the New Coil: Before installing the new coil, prime it. Add a few drops of e-liquid directly onto the cotton-wicking material inside the coil. This helps to prevent dry hits and ensures the coil is saturated with e-liquid before use.

Step 5: Install the New Coil

1. Screw in the New Coil: Insert the new coil into the base of the Tank and screw it in by turning it clockwise until it is snugly in place. Ensure it is securely attached, but do not overtighten.

Step 6: Reassemble the Tank

1. Reattach the base to the Tank: Once the new coil is installed, screw the base of the Tank back onto the top section with the glass tube.
2. Refill the Tank (if needed): If you need to refill the Tank with e-liquid, now is a good time to do so. Slide the top cap to the side to reveal the fill port, and carefully pour your e-liquid into the Tank. Close the top cap securely after filling.

Step 7: Let the Coil Soak

1. Wait a Few Minutes: Allow the new coil to soak in the e-liquid for about 5-10 minutes before you start vaping. This ensures the cotton inside the coil is fully saturated and helps prevent dry hits.

Step 8: Reattach the Tank to the Mod

1. Screw the Tank Back Onto the Mod: Once the coil is fully saturated, screw the Tank back onto your vaping device.

Step 9: Adjust Settings (if needed)

1. Set Your Preferred Settings: If your vaping device has adjustable settings, set them according to your preference. Refer to the recommended wattage range for the new coil, usually indicated on the coil itself or in the user manual.

Step 10: Enjoy Vaping

1. Start Vaping: Your Vaporesso NRG Tank is now ready to use with the new coil. Start with a few gentle puffs, allowing the coil to break in gradually.